hey there everone!! im trying to help my girlfreinds dad restore a honda 500 four and its going alrite atm but were trying to 'sync' the carbs using one of the carb syncing tools which you hang on the bars and its got four lillte rods which you connect to the carbs!!!
THING IS! where do you connect them??? in the book it says about little cross head screws on the left hand side off the carbs which you then screw the adapters which then the with the vacume move the rods!! but where the bloody hells the little screws? any one done this before? pictures would be a total result!!
thanks dom
hi ,if you look in front of the carby at the inlet manifold youll see a small philips head screw facing downward slightly ,,one on each runner.,not on the carby but closer to the head..cheers,,it makes a big difference when its all synced up,,remove the tank and rig up longer fuel lines..